LNS Bar Loader Collets

Bar Loader Collets
Style D

CAT. NO. S & M	D MM & IN.	I.D. MM	L MM	CROSS HOLE MM	*RANGE INCHES
LN6D	6 (.236)	4 x .7	30	----	.078 -- .192
LN7D	7 (.276)	5 x .8	37	----	.118 -- .231
10D	10 (.394)	7	40	4.2	.197 -- .350
12D	12 (.472)	8	40	4.2	.236 -- .428
LN14D	14 (.551)	8	40	4.2	.315 -- .507
15D	15 (.591)	11	40	6.2	.393 -- .546
18D/15	18 (.709)	11	40	6.2	.511 -- .664
20D	20 (.787)	14	65	8.2	.511 -- .743
LN21D	21 (.827)	14	65	8.2	.551 -- .782
22D/20	22 (.866)	14	65	8.2	.630 -- .822
25D	25 (.984)	20	65	8.2	.708 -- .940
LN27D	27 (1.063)	20	65	8.2	.827 -- 1.018
28D	28 (1.102)	20	65	8.2	.886 -- 1.058
LN30D	30 (1.181)	20	65	8.2	.984 -- 1.083
LN32D	32 (1.260)	20	65	8.2	.984 -- 1.142

"D" Style Collets are supplied with a cross hole for pin mounting.

Click here for Bar Loader Collet information and pricing!

Bar Loader Collets
Stlye DL

CAT. NO. S & M	D MM & IN.	ID MM	L MM	SET SCREW MM	*RANGE INCHES
34DL	34 (1.339)	20	90	8 x 1.25	1.102 -- 1.220
36DL	36 (1.417)	20	90	8 x 1.25	1.181 -- 1.300
38DL	38 (1.496)	20	90	8 x 1.25	1.260 -- 1.378
40DL	40 (1.575)	20	90	8 x 1.25	1.339 -- 1.467
42DL	42 (1.654)	20	90	8 x 1.25	1.417 -- 1.535

“DL” Style Collets all have a 20mm rear bore for mounting and are secured with two set of screws. The common mounting feature allows interchanging the collets between different units.

*The bore range listed is recommended by LNS as the most desirable to use in their unit. Bores below listed minimum are available in fractional or decimal sizes.

Unless otherwise specified, bar loader collets are set to normal tension. If an application requires a lighter or heavier tension, please specify when ordering.

Click here for Bar Loader Collet information and pricing!